Welcome to DFRobot: www.DFRobot.com.cn 28 / 49
Project4 I2C
I2C of FireBeetle Board-ESP32 can be set to all I/O and allocated by uploading relative data. We
have already set the default configuration to make it more convenient to use. It is fully
compatible with Arduino. Look up the Chapter1, the introduction, the default pins. The project
based on the default configuration of I2C to drive OLED display screen.
Components in need
1×Gravity I2C OLED-2864 Display Screen
Caution: Please use Gravity port of the sensor to get more convenient experience, plug and play.
1×FireBeetle Covers-Gravity Adapter Board
Caution: FireBeetle Covers-Gravity Adapter Board is better for freshman to do ADC, plug and play.
To Next Page
Loading...