Welcome to DFRobot: www.DFRobot.com.cn 17 / 49
A message of Done compiling will be displayed in the information window after few seconds if
your operation is right. The message showed a successful compilation. Please backup to check
whether the processing is completed if any error.
After the programing, please choose Tools->Board-> FireBeetle-ESP32. In general, this step
performs only once on first use if you would not change the board.
Switch to Tools->Port, according to the number of serial port shown in the FireBeetle Board-ESP32,
we should choose COM3 as the communication port. The communication port appears only
when the development board has connected to a computer and been successfully recognized.
We should confirm the communication port carefully before every uploading, for a development
board may occupy different ports after insertion and extraction.
After the choice of COM, the information of board and port shows in the lower right of the
window.
To Next Page
Loading...