EasyManua.ls Logo

DGFLOW Steadypres - Main Parameters (SET1)

DGFLOW Steadypres
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
Parametri Principali (SET1)
A partire dal FUNZIONAMENTO NORMALE o dal
FUORI SERVIZIO è possibile entrare in modalità
SET 1 per settare i 3 parametri di base:
P - pressione di settaggio dell’impianto,
espressa in bar.
A - corrente nominale di targa del motore,
in Ampere.
Ro - senso di rotazione pompa.
Main Parameters (SET1)
Starting from NORMAL FUNCTIONING or from
OUT OF SERVICE, it is possible to enter SET 1
mode to set the 3 basic parameters:
P - system setting pressure, expressed in bar.
A - motor plate nominal current, in Amperes.
Ro - pump direction of rotation.
Attenzione: quando STEADYPRES è fornito
già installato su pompe o gruppi DGFLOW i
valori dei 3 parametri di base sono preimpo-
stati in fabbrica in funzione del tipo di pompa
collegata all’inverter.
In SET 1 tali valori possono essere modicati, ma
il loro campo di variabilità è limitato in funzione del
particolare tipo di pompa installata, per evitare che
un errato settaggio dei parametri possa far funzio-
nare la pompa fuori dal campo di corretto utilizzo.
Attention: when STEADYPRES is supplied
already installed on pumps or DGFLOW units,
the values of the 3 basic parameters are set
in the factory depending on the type of pump
connected to the inverter.
In SET 1 these values can be modied, but their
range of variability is limited depending on the
particular type of pump installed, to prevent an
incorrect parameters setting make the pump
function outside of its correct range of use.
Congurazione dei parametri Conguration of the parameters
EN
IT
Segnalazioni visive Visual signals
E’ in corso il Settaggio dei
parametri principali.
Note: con i tasti Freccia si pas-
sa alla visualizzazione degli altri
Parametri. Con i tasti “+“ e “-“
si variano i valori attuali indicati
con il lampeggio.
Main parameters setting is
in progress.
Notes: use the arrow keys to
display the other parameters.
Use the “+“ and “-“ keys to
vary the current values indica-
ted by ashing.
POWER
STATUS
P X . X
Lampeggio Alternato.
Alternate Flashing.
Luce spenta Luce accesa Luce lampeggiante
Light off Light on Light ashing

Related product manuals