11.4.1.2.Label Contrast [ 7 4 1 2 ]
The value of this parameter (from 0 to 9) is in direct
proportion to the contrast with which the labels will be
printed.
Enter the value of the contrast as a number between 0 and 9
(default value 5).
Press ∗
∗∗
∗ to save and move on to program overall format or
press MENU 2 seconds to quit the programming menu.
11.4.1.3.Label Format [ 7 4 1 3 ]
With this parameter, whose value goes from 0 to 30*, you
can decide in which format by default the labels will be
printed, in such a way that if it is set at:
‘0’ ⇒ Then the label will be printed in the format assigned to
each article.
If the PLU label format field has been assigned an ‘0’
then the printing format will by default be ‘1’.
Quick change Format Label, Working in normal mode,
press PRINT
From ’1’ to ‘20’ ⇒ then the format in which all article labels
will be printed will be the one selected from among the
existing pre-designed ones, regardless of the one assigned
to each PLU when creating the articles.
From ‘21’ to ‘30*’ ⇒ then the format in which all article labels
will be printed will be one of those designed, regardless of
that assigned to each PLU at the creation stage of the
articles.
Press ∗
∗∗
∗ to save and move on to program the headline or
press MENU 2 seconds to quit the programming menu.
* Models.
•: W-015 & M-515 Maximum 25
•: W-025 & M-525 Maximum 30
To Next Page
Loading...
