EN OPERATION
DiBO 22
1 Settings (remote control 1)
When one pushes the reset button during 5 seconds, it is possible to browse
through menu on the screen of the cleaner. One can select these commands
now: ’remote control and delay time of remote control’(see beneath).
1 REMOTE CONTROL
By selecting this command one can choose if you want to use/use not the
remote control.
Remark: When one uses the remote control , you can not use the
cold water button and hot water button (see 4.2) on the display of
the cleaner. The other buttons on the display are still available.
2 DELAY TIME OF REMOTE CONTROL
With this command it is possible to regulate the time how long the remote
control / cleaner needs to be active (through the + and - buttons). When the
regulated time is exceeded the remote control will turn o, also the lamp of the
on/o push- button will not shine anymore. So the cleaner switches over to a
not- active mode. One can operate back the remote control by pushing the on/
o push- button (< delay time) (the lamp of on/o button shall shine again). The
cleaner becomes active again. As long as the lamp shines, one can simply work
further with the cleaner. When the spray pistol isn’t been used during a short
time, the remote control shall not fail but remain in a safe mode (lamp keeps
shining), when you push the spray pistol you can work further again. Just when
the delay time is elapsed, the cleaner will fall out fully. The delay time starts
running when you loosen the spray pistol and will be reset again when one
sprays longer than 10 seconds. At a possible disturbance, the lamp of the on/o
push- button will flicker. Check the operating panel of the cleaner to see the
fault message and to repair it. The lamp shall stop flicker when the fault on the
operating panel is solved.
2 Settings (remote control 2)
• Machine o (main switch o) = LED on/o switch does not glow.
• Machine on & functioning ok (main switch on) = LED on/o switch lights
continuously irrespective if the on/o switch will be switched on/o.
• Machine in failure = LED on/o switch flashes, flash frequence depending
type o disturbance.
• In case of disturbance you can reset this by turning on/o this switch.
remote control 1
remote control 1
To Next Page
Loading...
Need help?
General
