4. Guidelines for the HYDRUS
Do not break the seal on the HYDRUS!.
A broken seal immediately voids the factory warranty.
IZAR@MOBILE2 software is used to read data and set parame-
ters. This software can be found at https://www2.diehl.com/
metering/en/diehl-metering/support-center/downloads.
5. Transport and storage
Water meters are precision devices! They must be protected
against impacts and vibration!
Make sure the meter is protected against frost when in storage
and during transport (the HYDRUS can be damaged by the ef-
fects of frost)!
6. Mounting / Installation
Install in accordance with the manufacturer's specications and/
or AWWA M6 standard.
Do not install ultrasonic meters near areas subject to a sudden
drop in pressure.
Install the HYDRUS only in waterpipe frostfree areas!
If there is danger of frost, drain the waterpipe and remove
HYDRUS if necessary.
Install using supplied ber washers in order to properly seal
connection to service line.
-6-
HYDRUS
English
To Next Page
Loading...
