Digi AnywhereUSB 8 Plus

Configure the AnywhereUSB Manager from the command line device name
AnywhereUSB® Plus User Guide
92
device name
Purpose
Change or assign the local name of a device.
Syntax
>awusbmanager device name,< address >,< new name >
The <device name> is the device's address.
The <new name> is the new local name for the device.
Examples
Run the list command to determine the device's address.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "Hub 1" (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the device name command.
>awusbmanager device name,AW02-000001.1101,USBStick
Run the list command again to verify the name change.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "Hub 1" (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro "USBStick" (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service