AnywhereUSB User Manual (90001085_F1) 45
Retry if the LKA update fails
If enabled, when a LKA update fails, the Digi device server will wait the
specified amount of time before retrying the LKA update.
Advanced Settings
These settings are used in advanced situations and the defaults are
typically suitable for most environments. These settings are used to
control the keep alive settings of the various interfaces and should only
be changed when the defaults do not properly work.
Disconnect when Connectware Management is idle
Idle Timeout
Enables or disables the idle timeout for the connection. If enabled, an idle
connection will be ended after the specified amount of time.
Receive/Transmit Interval
Wait Count
Specifies the keep-alive interval to specify for packets received and
packets transmitted. These settings are used in conjunction with the Wait
Count to signal when the connection has been lost.
Connection Method
Specifies the method by which the associated interface connects to the
remote server. The default TCP is typically good enough for most
connections, and it is the most efficient method of connecting to the
remote server in terms of speed and transmitted data bytes. The value
Automatic is less efficient, but it is useful in situations where a firewall or
proxy may prevent direct connection via TCP. Automatic will try each
combination until a connection is made. Note that None has the same
effect as selecting TCP.
HTTP over Proxy Options
Specifies the proxy settings required to communicate over a proxy
network using HTTP. These settings only apply when Automatic or HTTP
over Proxy is selected.
To Next Page
Loading...
Need help?
General
