Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
51
n Enable: Enables or disables the configured socket tunnel.
n Timeout (seconds): The timeout, specified in seconds, controls how long the tunnel will
remain connected when there is no tunnel traffic. If the timeout value is zero, then no timeout
is in effect and the tunnel will stay up until some other event causes it to close.
n Initiating Host: The hostname or IP address of the network device which will initiate the
tunnel. This field is optional.
n Initiating Port: Specify the port number that the Digi device product will use to listen for the
initial tunnel connection.
n Initiating Protocol: The protocol used between the device that initiates the tunnel and the
Digi device server. Currently, TCP and SSL are the two supported protocols.
n Destination Host: The hostname or IP address of the destination network device.
n Destination Port: The port number that the Digi device will use to make a connection to the
destination device.
n Destination Protocol: The protocol used between Digi device and the destination device.
Currently, TCP and SSL are the two supported protocols. This protocol does not need to be the
same for both connections.
n Click Add to add a socket tunnel. Click Apply to save the settings. Once the socket tunnel is
configured, select the Enable check box to enable the socket tunnel.
Advanced Network Settings
The Advanced Network Settings define the network interface. These settings rarely need to be
changed. Contact your network administrator for more information about these settings.
IP settings
Use the IP settings to manage IP address configuration.
n Host Name: The host name to be placed in the DHCP Option 12 field. This is an optional setting
which is only used when DHCP is enabled.
The host name is validated and must contain only specific characters. These restrictions are as
defined in RFCs 952, 1035, 1123 and 2132. The following characters are permitted:
l Alphabetic: upper and lower case letters A through Z and a through z
l Numeric: digits 0 through 9
l Hyphen (dash): -
l Period (dot): .
You can specify the host name value as a single name or a fully qualified domain name, whose
parts are separated with a period character. Each part must follow the following rules:
l Must begin with a letter or digit
l Must end with a letter or digit
l Interior characters may be a letter, digit or hyphen
To Next Page
Loading...
Need help?
General
