Command descriptions set socket_tunnel
ConnectPort® LTS Command Reference
127
The timeout (specified in seconds) controls how long the tunnel will remain connected when there is
no tunnel traffic. If the timeout value is zero, then no timeout is in effect and the socket tunnel will
stay up until some other event causes it to close.
from_hostname={name|ip address}
The initiating host: the hostname or IP address of the network device that initiates the socket tunnel.
from_port=port number
The initiating port: the port number that the ConnectPort LTS product uses to listen for the initial
socket tunnel connection.
from_protocol={tcp|ssl}
The initiating protocol: the protocol used between the device that initiates the socket tunnel and the
ConnectPort LTS product. Currently, TCP and SSL are the two supported protocols.
to_hostname={name|ip address}
The destination host: The hostname or IP address of the destination network device.
to_port=port number
The destination port: the port number that the ConnectPort LTS product uses to make a connection
to the destination device.
to_protocol={tcp|ssl}
The destination protocol: the protocol used between ConnectPort LTS product and the destination
device. Currently, TCP and SSL are the two supported protocols. This protocol does not need to be the
same for both connections.
See also
n revert
n show
n The section on socket tunnel settings in the ConnectPort LTS User Guide.
To Next Page
Loading...
Need help?
General