Command descriptions rlogin
ConnectPort® LTS Command Reference
48
rlogin
Purpose
Performs a login to a remote system, also referred to as an rlogin.
Required permissions
For products with two or more users, permissions must be set to
“set permissions rlogin=execute” to use this command. See "set permissions" for details on setting
user permissions for commands.
Syntax
rlogin [esc=
character
]
[{user=
username
}]
[
ip address
]
Options
esc= character
A different escape character than the ~ (tilde) character, which will be used for the current Rlogin
session. This character is used for suspending a session from the remote host to return to the device
server command line.
user=username
The user name to use on the remote system. If you do not specify a name, your device server user
name will be used.
ip address
The IP address of the system to which you are performing the remote login.
Example
#> rlogin 10.0.0.1
See also
n telnet
n connect
n status
n close
To Next Page
Loading...
Need help?
General