Command descriptions set alarm
ConnectPort® LTS Command Reference
50
The default is “off.”
Options for setting multiple alarms with the “range” option
range= {1-32}
Specifies the alarm or range of alarms for which alarm options are set.
active={on|off}
Enables or disables an alarm.
on
Enables an alarm.
off
Enables an alarm.
The default is “off.”
cc=string
The text to be included in the “cc” field of an alarm-triggered email.
priority={normal|high}
The priority of the triggered email.
normal
The email is sent with normal priority.
high
The email is sent with high priority.
The default is “normal.”
subject=string
If “type=email,” this option specifies the text to be included in the “subject” field of an alarm-triggered
email. If “type=snmptrap,” this option specifies the text to be included in the “Serial Alarm Subject”
field of an alarm- triggered SNMP trap.
to=string
The text to be included in the “to” field of an alarm-triggered email.
type={email|snmptrap|all}
Used to determine what kind of an alarm is sent: an e-mail alarm, an SNMP trap or both.
For SNMP traps to be sent, the IP address of the system to which traps are sent must be configured,
by issuing a “set snmp” command with the “trapdestip” option. See "set snmp."
email
An email alarm is sent.
snmptrap
An SNMP trap is sent. If snmptrap is specified, the “subject” text is sent with the alarm.
The MIBs for these traps are DIGI-SERIAL-TRAPS.mib, and DIGI-BOBILETRAPS.mib.
all
To Next Page
Loading...
Need help?
General