Command descriptions set ethernet
ConnectPort® LTS Command Reference
60
set ethernet
Purpose
Configures, adjusts, and displays Ethernet communications options.
Required permissions
For products with two or more users, permissions must be set to “set permissions s-ethernet=read”
to display Ethernet communications options, and “set permissions s-ethernet=rw” to display and
configure Ethernet communications options. See "set permissions" for details on setting user
permissions for commands.
Syntax
Configure Ethernet communications options
set ethernet [index=1-2]
[duplex={half|full|auto}]
[speed={10|100|1000|auto}]
Display Ethernet communications options
set ethernet
Options
index=1-2
Used to specify the index of the Ethernet device
duplex
Determines the mode the ConnectPort LTS product uses to communicate on the Ethernet network.
Specify one of the following:
half
The device communicates in half-duplex mode.
full
The device communicates in full-duplex mode.
auto
The device senses the mode used on the network and adjusts automatically.
The default is “auto.” If one side of the Ethernet connection uses auto, the other side
can set the duplex value to whatever is desired. If one side uses a fixed value (for
example, half-duplex), the other side has to use the same. If the “speed” value is set to
auto, auto is only allowed for the duplex value.
speed={10|100|1000|auto
To Next Page
Loading...
Need help?
General