Command descriptions set network
ConnectPort® LTS Command Reference
70
set network
Purpose
Sets and displays network configuration options.
Required permissions
For products with two or more users, permissions must be set to “set permissions s-network=read”
to display network configuration attributes, and “set permissions s-network=rw” to display and set
network configuration attributes. See "set permissions" for details on setting user permissions for
commands.
Syntax
Set network configuration options
set network [index=1-4]
[
ipv4 address options
]
[
ipv6 address options
]
[
dns options
]
[
tcp keepalive options
]
[
advanced ip options
]
Where:
[
ipv4 address options
] are:
[mode_v4={none|static|dhcp}]
[ip_v4=
device ipv4 address
]
[submask_v4=
subnet mask for ipv4 address
]
[gateway_v4=
gateway ipv4 address
]
[
ipv6 address options
] are:
[mode_v6={none|static|dhcp|auto}]
[ip_v6=
device ipv6 address
]
[gateway_v6=
gateway ipv6 address
]
[ip_6to4tunnel={off|on}]
[ip_v4_6to4relay=ipv4
address of remote
6to4 relay
]
[ip_v6_v4addr=
public ipv4 address for
6to4 tunneling
]
[
dns options] are
:
[manual_dns={off|on }]
[dns1=
primary dns server ip address
]
[dns2=
secondary dns server ip address
]
[
tcp keepalive options
] are:
[idle=10-86400] (seconds)
[probe_count=5-30]
[probe_interval=10-75] (seconds)
To Next Page
Loading...
Need help?
General