Digi One IAP Haz - Other Serial Port Protocol Profile: Serial-Connected Slave; Other Serial Port Protocol Profile: Serial-Connected Master

Configure the Digi One IAP using IAprofiles Other serial port protocol profile: serial-connected slave
Digi One IAP Family User Guide
15
Other serial port protocol profile: serial-connected slave
Use the serial-connected slave profile to connect a slave device to the serial port using any IA serial
port protocol not previously discussed in this guide.
Configuration requirements
In this configuration, you do not set up the port of the device server for an IA protocol; instead:
n If you will use RealPort for COM port redirection, you simply set up the port for RealPort.
n If you will have the master access the device server using TCP or UDP sockets, configure the
standard serial port parameters required by the attached slave, such as line speed, number of
data bits, and parity scheme.
No special network configuration is required in either case.
Setup information
n To set up the device server for RealPort, see Set up COMport redirection.
n To set up the port for an “unsupported” IA protocol, see Configure a serial-connected slave:
other IA protocol.
Other serial port protocol profile: serial-connected master
Use the serial-connected master profile to connect a master device to the serial port using any IA
serial port protocol not previously described in this section.
Configuration requirements
In this configuration, you do not set up the port of the device server for an IA protocol. Instead, you
configure the standard serial port parameters required by the attached master, such as line speed,
number of data bits, and parity scheme, and then configure the port for autoconnection.
Setup Information
See Configure a serial-connected master: other IAprotocol.