Digi SM-100 - 2.2 Specification Setting

SM – 100 Operation Manual
10
2.2 Specification Setting
2.2.1 Specification Entry(141)
Before setting 141, please enter Z mode.
OPERATION
DISPLAY
REMARK
PT kg
＄/kg ＄
Z1.0 RESET SALES DAILY
Z mode.
Lamp Z turns on.
[Rezero]+[1][4][1] SPEC 000
XXX
(setting)
XXX
(former)
Enter [1][4][1] while depressing
[Rezero].
XXX:SPEC data
[︾]
SPEC 001 XXX XXX
[ ︾ ]key only increase specification
count, it does not update SPEC data.
[︽]
SPEC 000 XXX XXX
[︽ ]key only decrease specification
count, it does not update SPEC data.
[1][7]
[X]
SPEC 000
SPEC 017
017
XXX
XXX
XXX
It goes to a designed specification
count.
(000~441 is enabled)
[>>] SPEC 017 XXX XXX
[>>] key select SPEC data.
Move cursor right.
[<<] SPEC 017 XXX XXX
[<<] key select SPEC data.
Move cursor left.
[1]
[*]
SPEC 017
SPEC 018
001
XXX
XXX
XXX
[C] SPEC 018 000 XXX Clear the enter data.
[PLU]
* Note 1
Z1.0 RESET SALES DAILY
Store the updated specification and
escape to Z mode.