SM-300 Operation Manual (Advance)
8
SETUP
Password Setting
This function is used to set password so only authorized person can access the modes for operation.
Password can be set for the following 4 modes and up to 6 digits can be entered as Password Code. [To
enable this programming mode, please set SPEC 64 to 0 (ALLOW) in advance.]
• Report Mode (X Mode)
• Programming Mode (S Mode)
• Total Mode (Z Mode)
• Password Setting (X Mode Password [“X” Indicator Blinking])
1. Procedures of Password Setting
1) Enter Password Setting Mode from Stand-by Status.
*If not necessary to set password for X Mode, just
press [PRINT] key again to go to next step (Password setting for S Mode).
KEY TO PRESS DISPLAY
¼O
»
NET
X MODE PASSWORD: 0
AM
P
X
CH
M
NEW: 0-9 / CLEAR: *
PE
2) Enter password code (Ex. 111) for Report Mode (X Mode).
KEY TO PRESS DISPLAY
¼O
»
NET
X MODE PASSWORD: 111
AM
P
X
CH
M
NEW: 0-9 / CLEAR: *
PE
Note: To escape without saving the X Mode password setting, press [MODE] key to exit (Back to Stand-by
Status).
3) Save the password code for X Mode.
KEY TO PRESS DISPLAY
¼O
»
NET
S MODE PASSWORD: 0
S
AM
P
CH
M
NEW: 0-9 / CLEAR: *
PE
To Next Page
Loading...
Need help?
General
