Safety Information
The operator of the equipment shall comply with the safety and warning indications and procedures
outlined in this document. Teraoka Weigh - System Pte Ltd assumes no responsibility or liability for
failure to comply with these requirements.
- To avoid electric shock, use only the supplied power cords and ensure product is connected
to a properly grounded supply.
- Ensure product is placed on a firm and level surface before operation.
- Avoid overloading the product beyond its rated maximum capacity.
- Ensure commodity to be weighed is loaded centrally on the platter, avoid placing commodity
on corners or edges.
- Care shall be taken during the following operations
~ Receipt paper tearing - to prevent injuries from cutting from paper cutter
~ Changing of labels and receipt paper - to prevent injuries from cutting from paper cutter
and movable printer mechanism.
- Repair and servicing of product shall only be carried out by trained and qualified personnel.
Disclaimer:
Specifications are subject to change without notice. All dimensions shown are approximate. Please
be aware that Teraoka has indicated that its hardware and software used in the product may
require additional updates in the future as our product is continually under development. The need
for such updates most likely applies to the Printer software.
CAUTIONS:
FOR PLUGGABLE EQUIPMENT, THAT THE SOCKET-OUTLET SHALL BE INSTALLED
NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME
TYPE AND RATING OF FUSE.
POUR NE PAS COMPROMETTRE LA PROTECTION CONTRE LES RISQUES D'INCENDIE,
REMPLACER PAR UN FUSIBLE DE MÊME TYPE ET DE MÊME CARACTÉRISTIQUES
NOMINALES.
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER.
DISCARD USED BATTERIES ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS
IL Y A DANGER D'EXPLOSION S'IL Y A REMPLACEMENT INCORRECT DE LA BATTERIE.
REMPLACER UNIQUEMENT AVEC UNE BATTERIE DU MÊME TYPE OU D'UN TYPE
RECOMMANDÉ PAR LE CONSTRUCTEUR. METTRE AU RÉBUT LES BATTERIES USAGÉES
CONFORMÉMENT AUX INSTRUCTIONS DU FABRICANT.
To Next Page
Loading...
Need help?
General
