Digi SM-5300 Series - Page 97

M o d e l S M - 5 3 0 0 U s e r M a n u a l | 96
Report Mode
––––––––––––––––––––––––––––––––––––––––––––––––
3.2 Entry to Report Mode
3.2.19 Batch Report
Batch Report is used to view/print transaction data separated by setting done in Batch Report
Programming. On Batch Report, Sales transaction report is printed depending on the setting done
in BATCH REPORT PROGRAMMING under Programming Mode [SETUP]. Please refer to Batch
Report File under Setup Programming Mode.
OPERATION
DISPLAY
1.
In REPORT GENERATOR screen touch
[BATCH] key and select 2: BATCH 2
2.
Touch [PREVIEW] key to view the report.
Note:
1. Touch [UP] or [DOWN] key, to view
continues of report.
2. Touch [EXIT] key to exit view PLU Total
Report.
3. Touch [ZOOM IN] or [ZOOM OUT] key
to zoom in or zoom out preview report.
3.
Touch [PRINT] key to print out the report.
Note:
1. Touch [MENU] key, to back to Menu
Mode display.