Digi SM-5300 - Page 112

Preset Key Assignment
–––––––––––––––––––––––––––––––––––––
3.4 Programming of Preset Keys
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 111
3.4.6 Mechanical Key Programming
In this mode allow default assigning of 28 preset keys for the entire PLU and other
Functions Keys (refer to Mechanical Key Layout). Usually in Mechanical Keys, Function and
other Functions Keys is being assigned. In Registration Mode, Mechanical Key can be select
by using the Keypad 1-28 on External keyboard. There are two methods to assign PLU and
other Functions on preset key.
Note: 1. Non-existing PLU and Function Numbers cannot be assigned.
3.4.6.1 PLU and other Function Assignment
OPERATION
DISPLAY
1.
In Preset Key Programming, Enter group
number (e.g. 0)
Note: Adjust Primary keys, Secondary keys and
Accumulation keys to desired display size
2.
Touch [MECHANICAL KEYS] key.
3.
Method 1: Assign by entering the existing
PLU Number by using the keypad.
Enter the PLU Number by the keypad. (e.g.
1)
Touch the desired preset key.