––––––––––––––––––––––––––––––––––––––––––––––––––––
6.2 Copy a Main Group File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 179
6.2 Copy a Main Group File
The programmed Main Group data can be easily copied into a new Main Group. The function is very
useful to save time or avoid mistake for the similar Main Group data programming, especially in case
of long description of Ingredients.
In Main Group Programming Mode, enter a
new Main Group number. (e.g. 2)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
Key in the desired Main Group data to copy
from (e. g. MG 1) and touch [ENTER] key
or touch desired MG.
Note: Change the necessary data if required.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.
To Next Page
Loading...
