Digi SM-5300 - Page 195

Text File
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
9.2 Copy a Text File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 194
9.2 Copy a Text File
The programmed Text data can be easily copied into a new Text. The function is very useful to save
time or avoid mistake for the similar Text data programming, especially in case of long description of
Ingredients.
OPERATION
DISPLAY
1.
In Text Programming Mode, enter a new
Text number. (e.g.11)
Touch [COPY] key.
Note: Touch or for more selection.
2.
Touch the desired Text data to copy from.
(e.g. Text 10)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.