Digi SM-5300 - Page 202

Clerk File
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
10.2 Copy a Clerk File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 201
10.2 Copy a Clerk File
The programmed Clerk data can be easily copied into a new Clerk. This function is very useful to save
time or avoid mistake for the similar Clerk data programming.
OPERATION
DISPLAY
1.
In Clerk Programming Mode, enter a new
Clerk number. (e.g. 16)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Clerk data to copy from.
(e.g. 15)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.