Digi SM-5300 - Page 213

Image File
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
11.2 Copy an Image File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 212
11.2 Copy an Image File
The programmed image data can be easily copied into a new Image. This function is time saving and
avoid mistake for the similar Image data programming.
OPERATION
DISPLAY
1.
In Image Programming Mode, enter a new
Image number. (e.g. 205)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Image data to copy from.
(e.g. 124)
Note: Change the necessary data if it is
required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.