Digi SM-5300 - Page 236

Place File
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
15.2 Copy a Place File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 235
15.2 Copy a Place File
The programmed Place data can be easily copied into a new Place. This function is very useful to save
time or avoid mistake for the similar Place data programming.
OPERATION
DISPLAY
1.
In Place Programming Mode, enter a Place
number. (e.g. 11)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Advertisement data to
copy from.
(e.g. Place 10 - Barelang)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.