Digi SM-5300 - Page 290

Slaughter House File
–––––––––––––––––––––––––––––––––––––––––––
22.2 Copy a Slaughter House File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 289
22.2 Copy a Slaughter House File
The programmed Slaughter House data can be easily copied into a new Slaughter House This function
is very useful to save time or avoid mistake for the similar Slaughter House data programming.
OPERATION
DISPLAY
1.
In Slaughter House Programming Mode,
enter a new Slaughter House number. (e.g.
11)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Slaughter House data to
copy from. (e.g. House #5)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.