Digi SM-5300 - Page 296

Cutting Hall File
––––––––––––––––––––––––––––––––––––––––––––––––––––
23.2 Copy a Cutting Hall File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 295
23.2 Copy a Cutting Hall File
The programmed Cutting Hall data can be easily copied into a new Cutting Hall. This function is very
useful to save time or avoid mistake for the similar Cutting Hall data programming
OPERATION
DISPLAY
1.
In Cutting Hall Programming Mode, enter a
new Cutting Hall number. (e.g. 11)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Cutting Hall data to copy
from.
(e.g. Cutting Hall 8)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.