Digi SM-5300 - Page 320

Traceability File
––––––––––––––––––––––––––––––––––––––––––––––––––––
29.2 Copy a Traceability File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 319
29.2 Copy a Traceability File
The programmed Traceability data can be easily copied into a new Traceability. This function is very
useful to save time or avoid mistake for the similar Traceability data programming
OPERATION
DISPLAY
1.
In Traceability Programming Mode, enter a
new Traceability number. (e.g. 2)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Traceability data to copy
from.
(e.g. Traceability 1)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.