Digi SM-5300 - Page 348

User Production Step File
–––––––––––––––––––––––––––––––––––––
34.2 Copy an User Production Step
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 347
34.2 Copy an User Production Step
The programmed User Production Step data can be easily copied into a new User Production Step.
This function is very useful to save time or avoid mistake for the similar User Production Step data
programming
OPERATION
DISPLAY
1.
In User Production Programming Mode,
enter a new User Production Step number
(e.g. 5)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired User Production Step data
to copy from.
(e.g. USER PRODUCTION STEP 4)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.