–––––––––––––––––––––––––––––––––––––
3.4 Programming of Preset Keys
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 97
3.4.3 Accumulation Key Programming
There is 1 page of preset keys in Accumulation Keys Programming Mode. In this mode
allow assigning maximum of 5 preset keys for Functions Keys and Flex_Func only, (refer to
Accumulation Key Layout). In Registration Mode, Accumulation Key can be use in the
Accumulation Mode. There are two methods to assign Functions on preset key.
Note: 1. Non-existing Function Numbers cannot be assigned.
2. FLEX_FUNC and IMAGE cannot be assigning at Accumulation Preset Key
3.4.3.1 Function Assignment
In Preset Key Programming, Enter group
number (e.g. 0)
Note: Adjust Primary keys, Secondary keys and
Accumulation keys to desired display size
Touch [ACCUMULATION] key.
Method 1: Assign by entering the existing
Function Number by using the keypad.
Enter the Function Number by the keypad.
(e.g. 41 for VOID PLU)
Touch the desired preset key.
To Next Page
Loading...
