Digi SmartSense Z User Manual

All rights reserved Digi International Inc. 91004331 91004329 A2/318
Equipment Manual
Troubleshooting Signal/ Sensor Reset
1. Quick Press of Power button (when device is already ON): This will trigger the sensor to
immediately ping the cell network and refresh its status online.
2. Long Press of Power Button: To shut down the Z Sensor hold the power button
(~15seconds) until all the LED lights turn off one by one. Then quick press the push
button to power up the Sensor again this will Reset the device
For Technical Support Call:
Digital Instruments 716-874-5848
LED 1 Blink 2 Blinks 3 Blinks Fast Blinking
Last transmission
successful
Last transmission
successful, but low
signal
N/A
Attempting to
transmit to a
Gateway
No external sensor Low battery N/A N/A
Not registered to
the SmartSense
Dashboard
No Signal
Failed to
communicate with
wireless radio
module
N/A

Digi SmartSense Z Specifications

General

Brand	Digi
Model	SmartSense Z
Category	Gateway
Language	English