Glass sides:
a. Fit the sides (P39) and (P40) so to form an arch;
b. Screw the sides using washer (P41) and screw (P8); repeat on the four fixing
points (two on the upper part, two on the lower part);
c. Fix the glass support (P42) to the rods' inner parts using washers (P25) 2x and
screws (P20) 2x in each support;
d. Fit the nut for the glass support (P45) to the glass support (P42); after the
nut was placed on the other side, place the two PVC washers (P44);
e. Repeat items “c” and “d” 16 times in each support fixation.
Quantity of parts used in this stage:
P8
= 4x - Hexagon head screws M10 x 20
P20 = 32x - M4 x 12cross head screw
P25 = 32x - D4flat washer
P39 = 1x - 2 side rods
P40 = 1x - 1 side rod
P41 = 4x - flat washer D10
P42
= 16x - glass support
P44 = 32x - PVC washer
P45
= 16x - glass support nut
This assembly will result in the set (P48) – Assembly of glass sides.
Torniquete
Tx1500
10
P39
P45
P41
P25
P20
P42
P44
P8
P40
To Next Page
Loading...