Touch RFID
Shared & Assigned Use Functionality
Product Guide
3
Express Register Manager Credentials
The Programming Key can quickly program multiple locks to operate with the same Manager Credentials.
Go to a lock already programmed to operate with the Manager Credentials.
Touch and hold
`
for 10 seconds. After 5 seconds, a two-tone beep will be
heard. After 10 seconds, two sets of two-tone beeps will be heard. Release
the hold and the LED will start to fl ash.
While the LED is fl ashing, insert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
Insert the Programming Key to program each lock to operate with the same
Manager Credentials.
Two sets of two-tone beeps will be heard and the LED will fl ash to
indicate successful programming.
End Express Registration mode:*
Go to any programmed lock.
Touch ` then insert the Programming Key.
Programming Instructions
12 43
Add Manager Credentials
Manager Credentials can be programmed to the locks at any time.
1
3
2
4
Go to a lock requiring additional
Manager Credentials.
Touch and hold
`
for 5 seconds
(a two-tone beep will be heard after
5 seconds) then release.
The LED will fl ash
.
While the LED is fl ashing, insert
the Programming Key.
A two-tone beep will be heard.
While the LED is fl ashing, insert each
additional Manager Key or present
each RFID Credential one at a time.
A beep will be heard for each
Manager Credential programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each lock or
follow instructions to Express Register
Manager Credentials to quickly
program multiple locks to operate
with the same Manager Credentials.
*The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.
or
To Next Page
Loading...
