Touch RFID
Shared & Assigned Use Functionality
Product Guide
4
RFID
CARD
Manager
RFID
CARD
Manager
Programming Instructions
1
1a 1b
2
2a 2b
Replace Programming Key or Manager Credentials
The locks must be reprogrammed to prevent the lost/stolen Programming Key or Manager Credentials from operating a lock.
To replace the Programming Key:
Note the order or serial number (found on the lock’s rear). Contact Digilock Support to purchase a replacement Programming Key.
To replace the Manager Credentials:
Collect all remaining and replacement Manager Credentials.
Go to any lock operated by the lost/stolen Manager Credentials.
Touch and hold
`
for 5 seconds (a two-tone beep will be heard after 5
seconds) then release.
The LED will fl ash.
While the LED is fl ashing, insert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Credentials will be erased.
Follow instructions to Add Manager Credentials to program the remaining
and replacement Manager Credentials to the locks.
Request Functionality Change
Note the order or serial number (found on the
lock’s rear).
Note the current color of the LED. To change the functionality of the locks
(between shared use and assigned use), contact
Digilock Support to request a Function Key.
132
LED Usage Indicator
Shared Use
Assigned Use
To Next Page
Loading...
