Digilock Numeris Versa Mini - ADA Handle Rotation Configurations

Touch RFID
Shared & Assigned Use Functionality
Product Guide
5
Programming Instructions - In Assigned Use Functionality
RFID
CARD
or
RFID
CARD
Manager
Assign User Credentials (for assigned use functionality only)
Make sure that the lock is set for assigned use functionality (a green LED will fl ash when ` is touched). Up to 20 user credentials (User
RFID Credentials and/or User Keys) may be assigned to each lock.
Touch and hold ` for 5 seconds
(a two-tone beep will be heard after
5 seconds) then release.
The LED will fl ash.
While the LED is fl ashing, insert a
valid Manager Key or present a valid
Manager RFID.
A two-tone beep will be heard
and the LED will turn on.
While the LED is on, insert each
User Key or present each User
RFID one at a time.
A two-tone beep will be heard for
each user credential successfully
programmed.
End Add Users:
Insert a valid Manager Key or present
a valid Manager RFID.
A two-tone beep will be heard
and the LED will turn off.
or
1324
Express Register User and Manager Credentials (for assigned use functionality only)
Make sure the lock is set for assigned use functionality (a green LED will fl ash when ` is touched). The Programming Key can quickly
program multiple locks to operate with the same user credentials and manager credentials.
Go to a lock already programmed to operate with the user and
manager credentials.
Touch and hold ` for 15 seconds. After 5 seconds, a two-tone beep will be heard.
After 10 seconds, two sets of two-tone beeps will be heard. After 15 seconds, three
sets of two-tone beeps will be heard. Release the hold and the LED will start to fl ash.
While the LED is fl ashing, insert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
Insert the Programming Key to program each lock to operate with the same user
and manager credentials.
Two sets of two-tone beeps will be heard and the LED will fl ash twice to indicate
successful programming.
End Express Registration:*
Go to any programmed lock
Touch ` then insert the Programming Key.
1
3
2
4a 4b
*The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.
RFID
CARD
Manager