Digital Extender HS-66M - Operation by Front Button; Product ID Setting

Copyright 2007 RTcom USA., Inc.
8
he functions of the switches are as follow.
Main power switch: matrix power on/off
tialize the matrix
nnel from 1 to 6 or 8
connection
AN) key: cancel current selection
Input # button: present set channels are displayed in sequence
→ Enter (ENT) button:
he connection of the channels are changed
ss cancel(CAN) button.
,4 output with same picture
ave (EDID) data
port cables on HDMI Matrix (The power set-top box should be unplugged (not sw. off)
, DVI monitor or AV Receiver),
, Power on both of HS-66M or HS-88M and Display (If you connect AV Receiver, disconnected display from the
# button (which is connected with display) → Input # button to be set
e o to matrix.
If t ligh
, P wer
, ect all input cables
6,
7,
#
#: Sele
- All push b
- If you use DV first.
Create - -># (ex: 1) -> OUT -># (ex: 1, 2, 3, 4) -> Enter
3-3 ro
•
• Dip switch sets in binary value.
T
•
• Remote controller receiver: receive infrared ray from remote controller
• Reset key: ini
• Input key: select cha
• 6 or 8 Output key: select channel from 1 to
• Create (CRE) key: change input/output channel
• Preview (PRE) key: preview the status of current
• Enter (ENT) key: save current selection
• Cancel (C
• h is connected to output EDID (EDI) key: read EDID data from display and then save data to matrix, whic
ports
3-2 Operation by Front Button
Input/output channel check:
Preview (PRE) button →
Input/output channel change
Create (CRE) button → Input # button set → Output ## button (Multiple selection) set
t
* If you want to cancel, and then pre
Example: CH# 1 input to 1,2,3
Create -> Input 1 -> Output 1,2,3,4 -> Enter
S
1, Disconnect the all input
2, Connect HDMI Matrix output to display directly (projector
3
Receiver)
DID (EDI) button → Select one of output3, E
(on r multiple) → Enter (ENT): Read EDID data of display and save them
(ENT) he t of the buttons on then just enter
o off all devices 4
5 Conn
Power on HDMI Matrix first.
Power on all the Input sources and display (Power plug in and turn on set-top box)
-
-#
: Select only on channel
ct multiple channels
uttons are on / off toggle (Light ON - Selected)
I display, the EDID data should be saved to matrix
IR Remote Control unit
>IN
P duct ID setting
Dip switch sets address for each matrix if many matrixes are used.