Ethernet Power Controller 7
digital-loggers.com
12
User Dened Links
Add hyperlinks to other power controllers, your own web pages,
or remote web sites by entering URLs in the Setup page. For
example, enter “Site Two Power Controller” in the description eld
and a URL of “192.168.0.250” These links appear on the left side
of the web pages.
Access Control
The administrator can grant users access to only certain
outlets. To set permissions, login as admin rst, then create
a permissions matrix by entering user names on the left and
checking allowed outlets on the right.
Network Settings
A valid xed IP address, network mask, and gateway must be
entered in this section.
When changing IPs, you may need to restart your network switch
to validate the new IP on an “auto-conguring” switch port. Be
sure to record the new IP address.
Use the Protect button to lock the network settings. Once
protected, the network settings cannot be changed except by
pressing the physical reset button below the LCD.
AutoPing
TM
AutoPing Operation and Settings
AutoPing is an automatic system for rebooting IP equipment
without human intervention. AutoPing will monitor a device. If
it stops responding, AutoPing can cycle power to reboot it. For
example, you might use AutoPing to monitor an external multi-
cast IP to automatically reboot a DSL router or WiFi AP.
To use AutoPing, rst add an IP address. Next, link that IP
address to one or more outlets. Timing settings must be
considered.
To Next Page
Loading...
Need help?
General