Ethernet Power Controller 7
digital-loggers.com
Meters & Charts
Histograms can be created with user-selectable time scales and
metering sources: AC input currents, AC input voltages, battery
voltage, and CPU / Relay voltages are metered. A thermistor
monitors CPU and control board temperature, which should never
exceed 185F. An external sensor port is provided for Dallas 1-wire
and similar sensors. The 5V meter monitors the control board
VCC, and the 12V meter indicates control relay power. Batteries
are fully charged at 5.60V and 90% discharged at 4.60V.
Safety Shutdown “E Breaker”
Supplementary over-current, over-voltage, and low-voltage
shutdown are provided on the safety shudown page. Take care
when conguring the E-Breaker so as not to create an oscillation.
Open Source Code
In compliance with the spirit of the GNU public license, most
source code is provided for reference. Purchasing a TLA and
signing an NDA from Atheros are highly recommended before
attempting any custom development. DLI cannot provide warranty
or tech support for modied units.
Tech Support
Please register. Painless online registration gets you free tech
support, rmware updates, and information. Check the FAQs link
below. Also note that internal help links are now context sensitive.
Suggestions
Looking for a new feature? Let us know:
engineering@digital-loggers.com We’ll listen.
FAQs
Please check the FAQs at:
digital-loggers.com/epcr7faqs.html
16
To Next Page
Loading...
Need help?
General