User Manual | 50
Record Mode “M” (Motion Detection) or “S” (Sensor/Alarm) uses the Event Recording Settings only.
[Event Record Setting]
Record Mode “C+M” (Continuous + Motion), “C+S” (Continuous + Sensor), or “C+M+S” (Continuous + Motion + Sensor)
simultaneously engages both Continuous and Event Recording Settings. DVR records with continuous
record settings, but when there is an event (Motion, Sensor, and Alarm), the DVR records with the Event
Record Settings.
Select “Off” as the Mode to disable a specific camera from recording.
Select the record Resolution for each camera channel. The Resolution is applied to both Continuous and Event
Record Settings.
[
Resolution Setup]
[Resolution] is the required number of horizontal and vertical pixels in a frame (horizontal pixels x vertical pixels). Select from the
options: 352×240/288, 720×240/288, and 720×480/576. Default is 352×240/288. Picture quality gets better, as the resolution
increases.
To Next Page
Loading...
