DigiTech BASS DRIVER User Manual

Connections
The Bass Driver has a single input (INPUT) and a pair of outputs (AMP
and MIXER). The two outputs give you the following options: running
into a bass amplifier, running directly to a mixing console or recording
device, or both. The MIXER output uses DigiTech’s advanced CIT™
cabinet modeling technology for an authentic bass amplifier sound
without using an amp. The CIT model is based on a 4x10 cabinet.
Follow these setup directions:
1.Turn the volume down on the amplifier/mixer you are connecting to.
2. Connect the pedal output to the amplifier/mixer input.
3. Connect the bass to the pedal input.
4. Connect the power supply to the pedal (optional).
5.Turn the LEVEL knob on the pedal to the minimum position.
6.Turn up your amplifier/mixer level to the preferred listening level.
7.Turn on the effect by pressing the PEDAL switch, and turn the
LEVEL knob up to the preferred listening level.

DigiTech BASS DRIVER Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Impedance

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 50Hz), PS200R - 240 (240V ~ 50Hz)

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs