6. Input Jack
Connect your bass to this jack. Connecting a cable to this jack engages
battery power even though the Indicator LED may be off. To prolong
battery life, disconnect cables from the pedal when not in use.
7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push either pin in to release the pedal from the chassis, exposing the
battery compartment. (See battery replacement diagram.)
8. Pedal
Turns the effect on and off.
9. Out 1(Amp) Jack
Connect this output to your bass amplifier.
10. Indicator LED
Indicates when the effect is turned on. If the LED becomes dim or does
not light when the cables are connected, the battery needs to be replaced.
To Next Page
Loading...
Need help?
General
