DigiTech BP355

21
Tremolo/Panner
A Tremolo effect modulates the volume of the signal at an even rate. The BP355 includes the
following Tremolo models: trmolo (the DigiTech
®
Tremolo), optrem (based on the Fender
®
Opto Tremolo), bitrem (based on the Vox
®
Bias Tremolo), and panner (the DigiTech Panner),.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed - Knob 3 adjusts the rate (Speed) at which the volume modulates. Ranges from 0
to 99
Depth - Knob 4 adjusts the intensity (Depth) of the modulating volume. Ranges from 0
to 99.
Waveform (DigiTech Tremolo and Panner only) - Knob 5 selects a waveform: tri-
ang, Sine, or Square.
Envelope Filter (eNvlOp)
The DigiTech Envelope Filter is a dynamic Wah effect that alters your sound based upon how
hard you play.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Sensitivity - Knob 3 adjusts the sensitivity or the input signal required to trigger the
Wah effect. Ranges from 0 to 99.
Range - Knob 4 controls the range of the Envelope effect. Ranges from 0 to 99.
DOD FX25 (fx25)
This envelope filter is based on the DOD FX25.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Sensitivity - Knob 3 adjusts the sensitivity or the input signal required to trigger the
Wah effect. Ranges from 0 to 99.
Range - Knob 4 controls the range of the envelope effect. Ranges from 0 to 99.