DigiTech BP355 User Manual

29
distortion from a clean sound to a distorted sound. Individual LFO speeds are also available
for assignment. In the previous example, the LFO speed would determine the length of time it
took the LFO to sweep from the clean to the distorted sound. The procedure for assigning the
LFOs in the BP355 is as follows:
1. Press the Edit button until the Expression row has been selected (indicated by the LED
lighting on the Expression row).
2. Rotate Knob 1 to select one of the two LFO links, LFO 1 (LFO1) or LFO 2 (LFO2) .
3. Rotate Knob 2 to select the parameter you want linked to the LFO 1 or LFO 2. See page
32 for a list of assignable parameters.
4. Rotate Knob 5 to select which waveform you want the LFO to use, Triangle (TRIanG), Sine
(SINE), or Square (SQUARE).
5. Rotate Knob 6 to select the speed you want the parameter to be controlled at.
Factory Reset
This function resets the BP355 to its original factory settings. This procedure erases all custom
User presets, and recalibrates the Expression Pedal.
ATTENTION: Performing this function will erase all user-programmed
data. All such data will be lost forever! Be sure you want to erase the
memory and start fresh before continuing with this procedure.
The procedure for performing a Factory Reset is as follows:
1. Press and hold the Store button while powering up the BP355.
2. When the display prompts you with FACRST, release the Store button, which is now flashing.
3. Press and hold the flashing Store button for 3 seconds until RSTORD appears in the display
and release. The Restore procedure takes several seconds to complete; during the proce-
dure, the display will count up. After the Restore procedure is complete, the Expression
Pedal calibration procedure will begin. See step two of the Expression Pedal Calibration sec-
tion below.
Expression Pedal Calibration
The Expression Pedal on the BP355 needs to be recalibrated for use after a factory reset has
been performed. This calibration procedure is automatically entered after a factory reset proce-
dure. (You can also initiate the calibration procedure by pressing and holding the Up and Down
Footswitches for approximately 5 seconds.) In the event the Pedal’s calibration fails, or if the
Pedal does not function properly, it can be re-calibrated using the Pedal Calibration procedure.
This will not erase the User presets. The procedure for Calibrating the Expression Pedal is as
follows:
1. Press and hold the Up/Down Footswitches until PDLCAL appears in the display (BYPASS,
TUNER, and Exit will be displayed before PDLCAL is accessed, after about 5 seconds.)
2. When the Display prompts you with TOE DN, rock the Expression Pedal forward (toe
down) and press either the Up or Down Footswitch.
3. When the Display prompts you with TOE UP, rock the Expression Pedal back (toe up)
and press either the Up or Down Footswitch.
4. The Display now prompts you to calibrate the V-Switch sensitivity (VSwxxx), where XXX is
the current V-Switch threshold. Rock the Expression Pedal forward and press firmly on
the toe once to turn the V-Switch on (wah ON), and again to turn the V-Switch off
(wahOFF).

DigiTech BP355 Specifications

General

Brand	DigiTech
Model	BP355
Category	Recording Equipment
Language	English