-13-
Call Tone setting
Call tone can only be transmitted once (not more than 3 sec) in any 60 sec
period.
It means that the unit will not transmit a call tone more than once no matter
how many times you press the button within a minute.
The unit is equipped with 5 user selectable Call tone melodies.
1. Press button ten times, until the C indicated and call tone code will
start blinking.
2. Press or button to set the desired melody, between the 5 available
melodies.
3. Press the button to transmit the Call Tone Melody.
Roger Beep Tone setting
The radio is equipped with a user selectable Roger Beep Tone feature, which
enables you to send a Beep Tone at the end of each transmission after every
release of the PTT Key.
This will prompt any receiving unit that your transmission has ended.
1. Press button eleven times, until the icon and the ON or OFF
indications will start blinking on the LCD display.
2. Press or button to set the desired selection ON (Roger Beep tone
enabled) or OFF(Roger Beep tone disabled). If the Roger Beep function is
enabled, a beep tone is heard to confirm the selection.
When the Roger Beep tone is enabled, the tone icon appears on the
LCD display.
Key Tone setting
When a key is pressed, a beep tone is heard to confirm your command. The
user many enable or disable this key tone.
1. Press button twelve times, until the icon and the ON or OFF
indications will start blinking on the LCD display.
2. Press or button to set the desired selection ON (Key tone enabled) or
OFF(Key tone disabled). If the Key tone function is enabled, a beep tone is
heard to confirm the selection.
3. When the Roger Beep tone is enabled, the tone icon appears on the
LCD display.
To Next Page
Loading...
Need help?
General
