DigiTech DIGIDELAY User Manual

7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the pedal chassis exposing
the battery compartment. (See battery replacement diagram).
8. Pedal
Press the pedal to turn the effect on and off. The Pedal is also used for
tapping in the delay time when using the Tap Tempo delay feature.
9. Out 1(Mono) Jack
Connect this output to a single guitar amplifier when only one amp or
mixer channel is being used.
10. Indicator LED
This LED indicates when the effect is turned on. When using the Tap
Tempo delay feature, the LED will flash at the rate of the delay time. If
the LED becomes dim or does not light when the cables are connected,
the battery needs to be replaced.

DigiTech DIGIDELAY Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs