Stomp Box Modeling
The BNX3 Stomp Box Modeling emulates the tones of the most popular distortion boxes ever used
including the DOD OD250, Boss DS-1,Arbiter Fuzz Face, Electro Harmonix Big Muff, ProCo RAT, DOD
Grunge, Boss Metal Zone, Ibanez TS-9,Voodoo Labs Sparkle Drive, and the Guyatone OD-2*.
*Arbiter, Boss, Electro-Harmonix, ProCo, Ibanez,Voodoo Labs, Guyatone, DS-1, Fuzz Face, Big Muff, RAT, Metal Zone,TS-9, Sparkle Drive, and
OD-2 are trademarks of their respective companies and are in no way associated with DigiTech
Stomp Box On/Off - The STATUS button turns the Stomp Box (Stompbox) Modeling on and off.
Stomp Box Type - The Parameter 1 knob selects the type of stomp box to be used. Choices include:
Screamer - Based on an Ibanez TS-9 Big MP - Based on the Electro Harmonix Big Muff Pi.
Fuzzy - Based on an Arbiter Fuzz Face Guy OD - Based on a GuyaTone OD-2
DOD 250 - Based on a DOD Overdrive 250 Rodent - Based on a Rat distortion
Grunge - Based on a DOD Grunge™. SprkDriv - Based on a Voodoo Labs SparkleDrive.
DS Dist - Based on a Boss DS-1. Zone - Based on a Boss Metal Zone.
Type Gain Param1 Param2 Param3* Param4* Level
Screamer drive tone level
Rodent dist filter volume
DS Dist dist tone level
DOD 250 gain level
Big MP sustain tone volume
Guy OD drive level
Sparkdrv gain tone clean volume
Grunge grnggain butt face loud
Fuzzy fuzz volume
Zone dist mid freq mid lvl low high level
Gain - Controls the amount of distortion or gain in the Stompbox model. Range is 0-99
Param1 - A tone control for the Stompbox model. Range is 0-99
Param2 - A second Tone control for the Stompbox model (not available in all models). Range is 0-99
*Param3 - Controls the Mid Frequency in the Zone stompbox model. Range is 0-99
*Param4 - Controls the Mid Level in the Zone stompbox model. Range is 0-99
Level - Controls the output level of the Stompbox model. Range is 0-99
EQ
Equalization helps shape the tonal response of your bass signal. The EQ in the BNX3 is similar to the
tone knobs on an amplifier with the exception that the BNX3 lets you choose the center frequency for
the Mid Range and Treble adjustments.
EQ Green/Red - The STATUS button adjusts the EQ when a Warped combination (green and red) of
amps is selected. This button does not function if only the green or red channel is
selected.
Bass Level - The Parameter 1 knob adjusts the amount of low end enhancement. Ranges from
Grn/Red
BASS
-12 to 12 (dB).
Mid Frequency - The Parameter 2 knob selects the frequency that the boost is applied by the Mid Level
knob. Ranges from 300Hz to 5000Hz.
Mid Level - The Parameter 3 knob adjusts the amount of mid range enhancement. Ranges from
Grn/Red MID -12 to 12 (dB).
Treble Frequency - The Parameter 4 knob selects the frequency that the boost is applied to by the
Treble Level knob. Ranges from 500Hz to 8000Hz.
* These Parameters are only available using the G
ENEDIT™ computer editor software.
23
Effects and Parameters
To Next Page
Loading...