Tre ble Level - The Parameter 5 knob adjusts the amount of high end enhancement. Ranges from
Grn/Red TRBL -12 to 12 (dB).
Noise Gate
A Noise Gate is designed to eliminate hiss and ambient noise while you are not playing. A Noise Gate
can also be used to create an automatic swell in volume. The BNX3 includes two different types of Noise
Gates: Silencer™, and Pluck.The Silencer™ operates as a standard Noise Gate.The Pluck Noise Gate is
designed to close after every note (depending on the Pluck Sensitivity).This allows automatic volume
swells to occur on a note by note basis.
Gate On/Off - The STATUS button turns the Noise Gate (
gate) on and off.
Gate Type - The Parameter 1 knob selects between the Silencer™ (
Silencer) or Pluck (PLUCK) type
of Noise Gates.
Gate Threshold - The Parameter 2 knob sets the signal strength required to open or close the Noise
Gate. The Gate Threshold (
THRESHld) parameter ranges from 0 (opens easily) to
40 (requires strong signals to open).
Gate Attack - The Parameter 3 knob adjusts the length of time it takes the gate to open (
ATTACK) and
the signal to become audible once the Threshold has been exceeded. Ranges from 0
(immediate signal), to 9 (This setting will gradually ramp up the volume).
Pluck Sensitivity - Selects the threshold (
PLUCK) where the Gate re-triggers when using the Pluck
type Noise Gate. This parameter is only available when Pluck is the selected type of
Noise Gate. Ranges from 0 (requires strong input signals) to 99 (re-triggers with
weak input signals).
The Parameter 5 knob does not function when the Noise Gate is selected.
Chorus/Mod Effects
The Modulation Effects group is a multi-function module allowing you to select effects such as; Chorus,
Flanger, Phaser,Tremolo, Panner,Vibrato, Rotary Speaker,AutoYa™, YaYa™, Detune, and Pitch Shift. Only
one of the effects in this row can be used at a time. When the Chorus/Mod group is selected, the
STATUS button is used to turn the Effect (
effect) module on and off. The Parameter 1 knob is used
to select the type of effect. After selecting the type of effect in this module, the Parameter 2-5 knobs can
then be used to adjust the individual parameters associated with the selected effect. The following pages
describe each effect and their parameters in more detail.
Chorus
A Chorus adds a short delay to your signal.The delayed signal is modulated in and out of tune and
then mixed back with the original signal to create a thicker sound.
Parameter 1 - The Parameter 2 knob adjusts the rate (
Speed) of the modulation. Ranges from 1 to
99.
Parameter 2 - The Parameter 3 knob adjusts the intensity (Depth) of the modulation. Ranges from
1 to 99.
Parameter 3 - The Parameter 4 knob adjusts the PreDelay (
PREDeLaY) or length of time before the
Chorus effect is applied to the input signal. Ranges from 1 to 20.
* Parameter 4 - Selects the waveform used by the Chorus.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal. Ranges from L 99 to R 99.
* These Parameters are only available using the GENEDIT™ computer editor software.
24
Effects and Parameters
To Next Page
Loading...