1. Connect a MIDI cable from the BNX3 MIDI Out to the the MIDI In of a MIDI recording device or the
MIDI in of another BNX3.
2. Press the UTILITY button.The Utility button’s LED lights.
3. Using the MODE or DRUMS button, scroll to the left or right until
AMP DuMP (Amp Dump) is
displayed.
4. Use the DATA WHEEL to select the Amp number you want to dump.
5. Press STORE.The display reads
SND TO.
6. Use the DATA WHEEL to select the destination User Amp number.
7. Set the MIDI recording device to record.
8. Press STORE again.The display reads
send amp until the dump is complete at which time the display
briefly reads
DONE before it displays AMP DuMP.
9. Press EXIT to return to the BNX3 presets.
NOTE:The Amp Dump sends information on the MIDI channel defined in the MIDI Channel menu.
MIDI Mapping
MIDI Mapping provides access to all factory and user presets from external MIDI program change
commands that may not correspond to the BNX3 preset. This is useful when multiple MIDI devices are
chained together and controlled by one central unit. For example, the main MIDI controller can send out
a program change command telling a particular MIDI unit to change to Program 10, but you may want the
BNX3 to change to User Preset 27. You can remap the BNX3 so when it receives MIDI Program change
10, it calls up User Preset 27. The Procedure for mapping MIDI program changes is as follows:
1. Press the UTILITY button.The Utility button’s LED lights.
2. Using the MODE or DRUMS buttons, scroll to the left or right until
M 1>U.is displayed.
3. Use the DATA WHEEL to select the incoming MIDI program number you want to remap. Notice
the flashing number to the right of the
M increases and decreases as you turn the Data Wheel.
4. Press the DRUMS button. Notice the number in the red numeric display begins flashing. This number
represents the BNX3 preset number that is accessed when the BNX3 receives the MIDI program
number shown to the right of the
M in the alpha-numeric display.
5. Rotate the DATA WHEEL to select the preset number the BNX3 will use when it receives the
selected MIDI program change.
6. Press EXIT to return to the BNX3 presets.
MIDI Merge
The MIDI Merge function echos the incoming MIDI data to the MIDI Out port of the BNX3. This is
useful when multiple MIDI devices are chained together, and you want to pass incoming MIDI Data on to
MIDI devices downstream from the BNX3.The procedure for enabling or disabling the MIDI Merge
function is as follows:
1. Press the UTILITY button. The Utility button’s LED lights.
2. Using the MODE or DRUMS buttons, scroll to the left or right until
midimrge is displayed. The red
numeric display reflects the current MIDI Merge status On or OF.
3. Rotate the DATA WHEEL to select the status.
4. Press EXIT to return to the BNX3 presets.
Digital Level
When plugging the BNX3’s digital output into a recording device, it is important that the recording device
gets as much signal as possible without being pushed into digital clipping. If your recorder is not
receiving enough level from the BNX3’s digital output, you can boost it using the Digital Level option in
the Utility menu. The procedure for adjusting the Digital Level is as follows:
69
Other Functions
To Next Page
Loading...