DigiTech GeNetX BNX3 - Adjust the Noise Gate; Select and Adjust the Chorus

Adjust the Noise Gate
For your example, you want our Noise Gate to open quickly with a relatively weak signal. This type of
gate uses the Silencer™ with a low threshold and short attack time. To create this type of Noise Gate,
do the following:
1. Press the EFFECT SELECT DOWN button and the Noise Gate’s LED lights.
2. If the display reads off (Of), press the STATUS button until the display reads on (On).
3. Rotate the Parameter 1 knob until the display reads SILeNCeR for the type of gate.
4. Rotate the Parameter 2 knob to set the Threshold to 20 (this may need to be adjusted depending
upon your bass).
5. Rotate the Parameter 3 knob to set the Attack Time to 0 (fast attack).
Select and Adjust the Chorus
Next you wanted to thicken up the sound, by adding a subtle Chorus effect, in the following manner:
1. Press the EFFECT SELECT DOWN button again and the LED in the Chorus/Mod row lights.
2. If the display reads off (Of), press the STATUS button until the display reads on (On).
3. Rotate the Parameter 1 knob until the display reads Chorus (Chorus) for the effect type.
4. Rotate the Parameter 2 knob to set the Chorus Speed to 5.
5. Rotate the Parameter 3 knob to set the Chorus Depth to 30.
6. Rotate the Parameter 4 knob to set the PreDelay to 10.
7. Rotate the Parameter 5 knob to set the Chorus Level to 50.
35
Tutorial