6
from the Input 1 (Mono) jack when not in use. If the optional Harman
power supply is used, cables can remain connected.
7. Input 2 - Connect a second input to this jack for stereo operation.
Input 1 and 2 are processed separately through the stereo delay effect
and then fed to Outputs 1 and 2 to keep true stereo separation
between channels.
8. Foot Switch Release Pins - These two pins are spring loaded
hinges that hold the Foot Switch in place. See page 16 for information
on accessing and changing the battery. See page 12 for more
information on using and changing the Tails Switch settings.
9. Indicator LED - Lights when the effect is turned on. When battery
power is low (approximately 15 minutes before it dies), the Indicator
LED begins to dim giving you advanced warning that very shortly you
will need to replace the battery.
To Next Page
Loading...
Need help?
General
